The wireless main unit replaces the need to take your hand off the handlebar to reach up and pull the cord on the roll-off system. Not only is this safer, but faster, and means you're free to clear your vision whenever you NEED to!
The remote sits conveniently next to your grip, allowing easy access to press the button.
With a tap of the button, the arm pulls the cord in a rapid-fire motion, clearing vision in less than 1 second*
With the Ripper you no longer need to take your hand off the the handlebar to clear your vision!
It takes minutes to setup the Ripper and operation is as easy as pushing a button.
Feed the strap through the strap mounts, then slide the Ripper forward until it touches the back of the roll-off canister.
Pull out the pull-cord and hook the Ripper pull arm over the cord.
Turn on the unit then quick press the sync button to change between Auto-Burst or Momentary/Continuous mode.
Place wireless remote button in desired location, then screw back mount and tighten down.
The pull cord is still operational even when The Ripper is attached.
Sync the Ripper to multiple Wireless Remotes for multiple bike setups.
Extra buttons available
Universal goggle strap mount works with your favorite goggle roll-off system*.
Press Remote button to activate the Ripper for approx 1.5 seconds. Use this mode to clear vision automatically with a tap of the button.
Press & HOLD Remote button to activate the Ripper for desired time (up to 5 seconds). Use this mode to have more control of roll usage.
The Ripper will typically last up to 10 rolls before needing to be recharged via the micro-USB port on the main unit. Battery level is indicated by the 3 LEDs
At only 4.1oz (116g) it's lighter than the typical action camera setup and almost half the weight once you include action camera mounting hardware.
California Prop. 65 WARNING:
This product can expose you to Bisphenol A, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.